A mold is a long-term investment. We treat it like one.
Most Mold Problems Are Decided Before the Steel Is Cut.
By the time a mold comes back wrong, the decision that caused it was made weeks earlier — a wall thickness that wasn’t flagged, a gate location that wasn’t questioned, a tolerance that looked fine on paper but doesn’t survive the material.
We review every design before we quote.
Not as a formality — because we’ve seen what happens when that step is skipped. If your design has a problem, we tell you before a single tool is cut.
If we can’t hold your tolerance, we say so upfront.
The mold you receive is built to run your full production volume — not just pass your first inspection.
What We Build
| Item | Specification |
|---|---|
| Mold Type | Single cavity, multi-cavity, family molds |
| Precision Tolerance | ±0.005mm |
| Mold Base | Standard & custom |
| Surface Finish | As per drawing / SPI standards |
| Mold Trials | In-house, same facility as production |
| Documentation | Full dimensional report on first article |
Certified Tool Steel to Match Your Specs
The steel you choose determines how long your mold lasts and how consistent your parts stay over a full production run.
We specify steel grade based on your material, your shot volume, and your surface finish requirement — not by default.
| Application | Commonly Used Steel |
|---|---|
| General purpose | P20, 718H |
| High-volume / wear resistance | H13, S136 |
| Corrosion resistance | S136, 420SS |
| Polished / optical surfaces | S136, NAK80 |